We're proud to introduce the 3" Block Kit and the 3" Pin Kit for all LCA bow presses. As compound bow limbs measure wider and wider, i.e., 2024 Mathews target/hunting bows. Your bow press fingers have to spread wider to accommodate. The 3" Block Kit is for any LCA bow press that's "copper" in color, and the 3" Pin Kit is for both "green" and "pack-n-go" press models.
Thank you for your continued support.
***NOTE: Our standard lead time applies.
Description:
This kit includes upgraded 3" wide blocks for your LCA bow press. Install these blocks onto any LCA press that is copper in color. By upgrading, you'd remove the narrow 2.5" blocks and install wider 3" blocks to help accommodate wider limb compound bow models hitting the market. Interchange the blocks easily following a few simple steps. See the instructional video below! The 2024 Mathews Title will require these wider blocks, but the additional width can also help with other models like Prime, Elite, Bear, Hoyt, PSE, and more.
If you have any LCA green or Pack-N-GO bow press models, purchase the 3" Pin Kit instead of the 3” Block Kit.
Included:
2 - 3" blocks
2 - 3" springsteel plates
4 - 5/16 mounting bolts
2 - Springsteel mounting screws
2 - Nut plates
Features:
• Wider base to accommodate wider limb bows
• Larger mounting bolts for reinforced strength
• More room for finger adjustments in/out
WARNING:
If you have an LCA bow press, always tighten your press block bolts periodically. If the bolts holding the blocks onto the bow press are loose, it can cause the bolts to become damaged. For the bolts to have full strength, they must be tight. You can tighten the bolts by removing the metal spring from the press block. The two bolts will reveal themselves underneath once you remove the spring. It's crucial to check these bolts periodically to ensure they are tight.
Item #: BK31001
***NOTE: Our standard lead time applies.
Description:
This kit includes upgraded 3" wide pins for your LCA bow press. Install these pins onto any LCA green or Pack-N-Go bow press model. When upgrading, you'll use an included pin pusher to remove the narrow 2.5" pins, and you'll use the same tool to install the 3" pins to help accommodate wider limb compound bow models hitting the market. Interchange the pins easily following a few simple steps. See the instructional video below. The 2024 Mathews Title will require these wider blocks, but the additional width can also help with other models like Prime, Elite, Bear, Hoyt, PSE, and more.
If you have an LCA bow press that's copper in color, purchase the 3" Block Kit instead of the 3” Pin Kit.
Included:
2 - 3" steel pins
2 - 3" springsteel plates
2 - Springsteel mounting screws
1 – Pin pusher
Features:
• Wider base to accommodate wider limb bows
• More room for finger adjustments in/out
Item #: PNK1001
