Ultimate EZ Deluxe

EZ Deluxe Press

Unboxing

EZ Deluxe Press main body

Pivot bracket assembly

Pivot locking handle

Four adjustable press fingers

One draw-stop finger

Four lag bolts with washers

Mounting the Press

Choose a solid and level mounting surface

Bolt or clamp the press securely to a bench or LCA Floor Stand

Permanent installations use the supplied lag bolts and washers

Temporary setups may use heavy-duty C-clamps

Check all mounting points for even tightness

Verify stability before inserting a bow

Safety Reminder: Always bolt or clamp securely

A loose or uneven mount can cause equipment damage or injury

Assembling the Deluxe Pivot System

Attach the press body to the pivot bracket using the included 9/16″ wrench

Tighten the main pivot bolt securely

Install the pivot locking handle on the side of the bracket

Test the pivoting motion to confirm smooth rotation

The locking handle secures the press in the desired horizontal or vertical working position

Installing & Adjusting the Press Fingers

Press down on the spring-steel tab and slide each finger into its rail slot

Adjust finger spacing to match limb width and cam profile

Use the rear thumb screws to fine-tune finger position

Ensure all fingers sit flush and evenly against the limb tips

Confirm there is no twist or side-loading of the limbs

Mark common bow setups on the rails for fast future adjustments

Placing the Bow in the Press

Open the press arms with the hand wheel until there is adequate clearance

Place the bow so the fingers contact the limb tips

For bows requiring half-moon or specialty adapters, seat fingers inside the grooves

Begin setup with the press in the horizontal position

Once aligned and snug, pivoting to vertical is optional for better access

Center the bow and ensure the riser is level

Turn the wheel slowly until all fingers make light, even limb-tip contact

Use thumb screws to finalize alignment

Pressing the Bow

Confirm all strings and cables are free from obstructions

Turn the wheel slowly to compress limbs evenly

Stop once tension is relieved enough for service

Perform string and cable replacement, peep installation, timing, or other tuning tasks

To access cams more easily, release the pivot lock, rotate the press vertical, and re-lock

Reverse the wheel slowly to release pressure until the bow returns to rest

Using the Pivot Feature

The pivot system allows rotation between horizontal and vertical working positions

Lock the pivot handle before applying or releasing pressure

Rotate only when the bow is snug in the fingers but not fully flexed

Pivoting provides easier access for serving strings, timing cams, and inspecting limb tracks

After Use & Maintenance

Wipe down the press after each use

Check pivot bolt, pivot handle, and mounting hardware for tightness

Inspect finger pins and thumb screws regularly

Lubricate moving components lightly if movement becomes stiff

Avoid lubricants on limb contact surfaces

Store indoors away from moisture and extreme temperatures

Troubleshooting

Press binds when turning wheel — contact LCA

Bow tilts unevenly when pivoted — tighten pivot lock and re-check mounting

Uneven limb pressure — adjust spacing and thumb screws for even contact

Loose mounting bolts — tighten hardware and re-test

Specifications & Compatibility

Model — EZ Deluxe Press (Manual)

Pivot range — horizontal to full vertical rotation

Limb tip spread — 25 to 48 inches

Mounting — bench or LCA Floor Stand

Frame — all-steel construction with powder-coated finish

Safety Guidelines

Always bolt or clamp the press securely before use

Keep hands and tools clear during pressing or releasing tension

Never exceed rated limb weight or press travel

Always lock the pivot handle before pressing

Release limb pressure slowly and evenly

Never leave a bow under pressure unattended

Store indoors, away from moisture or extreme temperatures.