Reserve PRO

1. What’s in the Box

• 1 Reserve Pro unit (with pre-installed bracket)
• 2 Lag bolts
• 2 Washers

Choice of Standard Bracket or Ultimate Bracket

Standard: Fits most LCA bow presses

Ultimate: Fits Ultimate EZ and Ultimate EZ Deluxe presses

2. Mounting Options
Option A: Table or Bench Mount

• Visit the LCA website under Media → Instructions to view the mounting diagram.
• Measure 2.5 inches from the table’s front edge to the back surface of the unit.
• This ensures handle clearance.
• Mark and drill pilot holes for lag bolts.
• Secure unit with the included lag bolts and washers using a 7/16” nut driver.

⚠️ Tip: Drilling pilot holes prevents bolt breakage and ensures a snug, sturdy mount.

Option B: Bow Press Mount

• Remove the front cap from your LCA bow press tubing.
• Keep the cap for re-installation when the jig is not in use.
• Slide the Reserve Pro bracket into the tubing until it clicks into place.
• To remove, pull the unit out and store on a shelf or cabinet.

3. Attaching the String or Cable

First End:

• Pop the locking pin from the wheel.
• Insert the loop of the string/cable over the pin.
• Reinsert the pin to secure.

Wind the Cable:

• Release the wheel’s locking pin and rotate to wind most of the string/cable.
• Lock the wheel again once aligned with the opposite end.

Second End:

• Repeat the same process: remove pin, insert loop, reinsert pin.
• Tighten the wheel as much as possible by hand, then lock it.

4. Adding Tension

• Turn the handle clockwise to increase tension.
• Continue until the desired pressure is reached.
• Maximum: 250 lbs tension (when the handle is flush against the unit).
• ⚠️ New strings stretch more, while older strings may require extra turns.

5. Re-Serving Process

• With tension applied, place the worn section between the two wheels.
• Use a serving jig to re-serve the section.
• The jig provides plenty of clearance to rotate around the string.

If moving to another section:

• Release tension by turning the handle toward you.
• Unlock pins, rotate wheels to desired section, and re-lock.
• Reapply tension with the handle.

Special Case: End Loops

• To re-serve through the loop at the string end, create a tag line from the pin/wheel to the string.
• This gives clearance to fully re-serve through the loop.

6. Applications

Re-serving worn areas (center serving, end loops, or cable sections).

Extending the life of your string or cable set.

Convenient field or shop repairs without replacing entire sets.